Mode d’emploi TOMY SR200 Digital Ecoute-bébé

Besoin d'un mode d’emploi pour votre TOMY SR200 Digital Ecoute-bébé ? Ci-dessous, vous pouvez consulter et télécharger gratuitement le mode d’emploi PDF en français. Ce produit a actuellement 2 questions fréquemment posées, 0 commentaires et a 1 vote avec une note moyenne du produit de 100/100. Si ce n'est pas le mode d’emploi que vous souhaitez, veuillez nous contacter.

Votre produit est défectueux et le mode d’emploi n’offre aucune solution ? Rendez-vous à un Repair Café pour obtenir des services de réparation gratuits.

Mode d’emploi

Loading…

GB
BABY UNIT
• GETTING TO KNOW YOUR MONITOR
PARENT UNIT
Microphone AC Adaptor jack
Power Indication Light
Power ON/OFF Button
Volume Control Buttons
Sound Level Lights Display
LINK Indication Light
Power Indication Light
Speaker
Sound Activated
Monitoring Light
Sound Activated
Monitoring Button
Power ON/OFF Button
Belt Clip/Battery
Compartment Cover
AC Adaptor Jack
•••
Low Battery on the Parent Unit
Power Indication Light will change
from solid green to ashing red.
Alarm tone on
Parent Unit
Alarm Meaning
Indications on the Parent Unit
Out of range
LINK Indication Light will change
from solid green to ashing red.
(Continuous)
3 beeps
••••••••
Fig.1 Fig.2
Fig.3
PARENT UNIT
Unscrew the battery compartment cover from the back of the unit (N.B: this
may already be supplied loose). Next, link the plug on the end of the battery
pack connector to the socket inside the unit, pushing the plug rmly into
the socket until it clicks. Place the battery pack into the compartment and
screw the cover back into position. See Figure 1.
Ensuring the power cable is correctly connected, plug your Parent Unit into
the mains supply and charge for a full 7 hours. See Figure 2. You can use
your monitor while it is charging by following the ‘SET UP’ guide below.
Important! Your Parent Unit will not function without rst inserting the battery pack.
BABY UNIT
The Baby Unit is powered by your domestic mains supply, using the power adaptor supplied.
Connect the adaptor to the back of the unit as shown in Figure 3.
Position the Baby Unit at least 1 metre away from your baby, ensuring all parts are kept out of
reach. Under no circumstances should you place any parts of the monitor in or on a cot. For
best performance, we recommend that the monitor is placed no further than 3 metres away
from your baby.
• SET UP
POWER ON
Make sure both the Baby and Parent Units are plugged into the mains and that the Parent Unit has its battery pack
installed (see above). The units should stand at least 1 metre apart.
Activate the Baby Unit by pressing and holding the ON/OFF Button
on the back of the unit until the green Power
Indication Light on the front lights up.
Next, activate the Parent Unit by pressing and holding the ON/OFF Button
located on the back (next to the battery
compartment cover) until the green light illuminates.
Note: If the Parent Unit is switched on before the Baby Unit, an out-of-range alarm will sound if the Baby Unit is not
switched on within 30 seconds.
POWER OFF
Switch off the Parent Unit by pressing and holding the ON/OFF Button
until the green light goes out.
Then, press and hold the Baby Unit’s ON/OFF Button
until the light goes out.
• BABY AND PARENT UNIT CONNECTION
As each unit activates, the LINK Indication Light
on the Parent Unit will ash as both Units auto-search and link to
each other. Once a connection is made between Baby and Parent Units, the LINK Indication Light will glow green
constantly and normal monitoring will start. The Sound Level Lights Display reacts to sound: the louder the sound, the
more lights illuminate.
• ALARM MODES
Identify the cause of an audible alarm by using the following table; should you be unable to identify or rectify the
cause of the problem, please refer to the Simple Solution Guide in these instructions.
GB
2
3
2 3
Télécharger mode d’emploi en Français (PDF, 5.59 MB)
(Tenez compte de l’environnement et imprimez ce manuel uniquement si c’est vraiment nécessaire)

Loading…

Évaluation

Dites-nous ce que vous pensez du TOMY SR200 Digital Ecoute-bébé en laissant une note de produit. Vous voulez partager vos expériences avec ce produit ou poser une question ? Veuillez laisser un commentaire au bas de la page.
Etes-vous satisfait du TOMY SR200 Digital Ecoute-bébé ?
Oui Non
100%
0%
1 évaluation

Joignez-vous à la conversation sur ce produit

Ici, vous pouvez partager ce que vous pensez du TOMY SR200 Digital Ecoute-bébé. Si vous avez une question, lisez d’abord attentivement le mode d’emploi. La demande d’un mode d’emploi peut être effectuée en utilisant notre formulaire de contact.

En savoir plus sur ce mode d’emploi

Nous comprenons qu’il est agréable d’avoir un mode d’emploi papier pour vos TOMY SR200 Digital Ecoute-bébé. Vous pouvez toujours télécharger le mode d’emploi depuis notre site Web et l’imprimer vous-même. Si vous souhaitez disposer d’un mode d’emploi original, nous vous recommandons de contacter TOMY. Ils pourront peut-être fournir un mode d’emploi original. Recherchez-vous le mode d’emploi de votre TOMY SR200 Digital Ecoute-bébé dans une autre langue ? Choisissez votre langue préférée sur notre page d’accueil et recherchez le numéro de modèle pour voir si nous l’avons disponible.

Caractéristiques

Marque TOMY
Modèle SR200 Digital
Catégorie Ecoute-bébés
Type de fichier PDF
Taille du fichier 5.59 MB

Tous les modes d’emploi pour TOMY Ecoute-bébés
Plus de modes d’emploi de Ecoute-bébés

Foire aux questions sur TOMY SR200 Digital Ecoute-bébé

Notre équipe d’assistance recherche des informations utiles sur les produits et des réponses aux questions fréquemment posées. Si vous trouvez une inexactitude dans notre foire aux questions, veuillez nous le faire savoir en utilisant notre formulaire de contact.

Pour quelle raison la plage de mon ecoute-bébé est-elle moins élevée que ce que la brochure/le manuel décrit ? Vérifié

Marques ont tendance à déclarer une gamme qui repose sur une utilisation sans obstacles comme des murs ou une distance qui s’étend sur plusieurs étages. Si la plage est insuffisante, essayez de placer l’ecoute-bébé pour qu'elle ait un minimum d'obstacles.

Cela a été utile (649) En savoir plus

En écoutant mon bébé, je peux clairement entendre la respiration, mais le moniteur de bébé ne me permet pas d’entendre cela. Et pourquoi donc ? Vérifié

Ceci est dû à la sensibilité du moniteur bébé. Réglez les paramètres pour être plus sensible et capter des sons plus silencieux.

Cela a été utile (326) En savoir plus
Mode d’emploi TOMY SR200 Digital Ecoute-bébé

Produits connexes

Catégories associées