Mode d’emploi Aiwa NSX-A10 Stéréo

Mode d’emploi

- .—.

NOTE

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more

of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and

receiver.

- Connect the equipment into an outlet on circuit different from

that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician

for help.

CAUTION

Modifications or adjustments to this product, which are not

expressly approved by the manufacturer, may void the user’s

right or authority to operate this product.

PRECAUTIONS

Read the Operating Instructions carefully and completely before

operating the unit. Be sure to keep the Operating Instructions

for future reference. All warnings and cautions in the Operating

Instructions and on the unit should be strictly followed, as well

as the safety suggestions below.

Installation

1

2

3

4

5

6

7

Water and moisture — Do not use this unit near water, such

as near a bathtub, washbowl, swimming pool, or the like,

Heat — Do not use this unit near sources of heat, including

heating vents, stoves, or other appliances that generate heat.

It also should not be placed in temperatures less than 5°C

(41‘F) or greater than 35°C (95”F).

Mounting surface — Place the unit on a flat, even surface.

Ventilation — The unit should be situated with adequate

space around it so that proper heat ventilation is assured.

Allow 10 cm (4 in.) clearance from the rear and the top of the

unit, and 5 cm (2 in.) from each side.

- Do not place the unit on a bed, rug, or similar surface that

may block the ventilation openings.

- Do not install the unit in a bookcase, cabinet, or airtight rack

where ventilation may be impeded.

Objects and liquid entry — Take care that objects or liquids

do not get inside the unit through the ventilation openings.

Carts and stands — When

placed or mounted on a stand or

cart, the unit should be moved with

care.

Quick stops, excessive force, and

m

“3

uneven surfaces may cause the

AA*

unit or cart to overturn or fall.

Condensation — Moisture may form on the CD pickup lens

when:

- The unit is moved from a cold spot to a warm spot

- The heating system has just been turned on

- The unit is used in a very humid room

- The unit is cooled by an air conditioner

When this unit has condensation inside, it may not function

normally. Should this occur, leave the unit for a few hours,

then try to operate again.

.

8

Wall or ceiling mounting

— The unit should not be mounted

on a wall or ceiling, unless specified in the Operating

Instructions.

.

Electric Power

1

2

3

Power sources — Connect this unit only to power sources

specified in the Operating Instructions, and as marked on the

unit.

Polarization —As a safety feature, some unitsare equipped -

with polarized AC power plugs which can only be inserted

one way into a power outlet. If it is difficult or impossible to

insert the AC power plug into an outlet, turn the plug over

and try again. If it still does not easily insert into the outlet,

please call a qualified service technician to service or replace

the outlet. To avoid defeating the safety feature of-the polarized

plug, do not force it into a power outlet.

AC power cord

- When disconnecting the AC power cord, pull it out by the

AC power plug. Do not pull the cord itself.

- Never handle the AC power plug with wet hands, as this

could result in fire or shock.

- Power cords should be routed to avoid being severely bent,

pinched, or walked upon. Pay particular attention to the cord

from the unit to the power socket.

- Avoid overloading AC power plugs and extension cords

beyond their capacity, as this could result in fire or shock.

1 FNGLISH

Évaluation

En savoir plus sur ce mode d’emploi

Nous comprenons qu’il est agréable d’avoir un mode d’emploi papier pour vos Aiwa NSX-A10 Stéréo. Vous pouvez toujours télécharger le mode d’emploi depuis notre site Web et l’imprimer vous-même. Si vous souhaitez disposer d’un mode d’emploi original, nous vous recommandons de contacter Aiwa. Ils pourront peut-être fournir un mode d’emploi original. Recherchez-vous le mode d’emploi de votre Aiwa NSX-A10 Stéréo dans une autre langue ? Choisissez votre langue préférée sur notre page d’accueil et recherchez le numéro de modèle pour voir si nous l’avons disponible.

Caractéristiques

Tous les modes d’emploi pour Aiwa Stéréos
Plus de modes d’emploi de Stéréos

Produits connexes

Mode d’emploi

Aiwa Z-L70 Stéréo

Mode d’emploi

Aiwa NSX-MA545 Stéréo

Mode d’emploi

Aiwa XR-M88 Stéréo

Mode d’emploi

Aiwa LCX-300 Stéréo

Mode d’emploi

Aiwa NSX-MT241 Stéréo

Mode d’emploi

Aiwa XH-A1000 Stéréo

Mode d’emploi

Aiwa NSX-V9000 Stéréo

Mode d’emploi

Aiwa XR-MD95 Stéréo

Catégories associées