Mode d’emploi Aiwa NSX-V8000 Stéréo

Mode d’emploi

PRECAUTIONS

Read the Operating Instructions carefully and completely before

operating the unit. Be sure to keep the Operating Instructions

for future reference, All warnings and cautions in the Operating

Instructions and on the unit should be strictly followed, as well

as the safety suggestions below.

Installation

1

2

3

4

5

6

7

8

Water and moisture — Do not use this unit near water, such

as near a bathtub, washbowl, swimming pool, or the like.

Heat — Do not use this unit near sources of heat, including

heating vents, stoves, or other appliances that generate heat.

It also should not be placed in temperatures less than 5°C

(41”F) or greater than 35°C (95°F).

Mounting surface — Place the unit on a flat, even surface.

Ventilation — The unit should be situated with adequate

space around it so that proper heat ventilation is assured.

Allow 10 cm (4 in.) clearance from the rear and the top of the

unit, and 5 cm (2 in.) from the each side.

- Do not place the unit on a bed, rug, or similar surface that

may block the ventilation openings.

- Do not install the unit in a bookcase, cabinet, or airtight rack

where ventilation may be impeded.

Objects and liquid entry —Take care that objects or liquids

do not get inside the unit through the ventilation openings.

Carts and stands — When

placed or mounted on a stand

or catt, the unit should be moved

with care.

Quick stops, excessive force,

and uneven surfaces may cause

the unit orcartto overturn or fall,

Condensation — Moisture may form on the CD pickup lens

when:

- The unit is moved from a cold spot to a warm spot

- The heating system has just been turned on

- The unit is used in a very humid room

- The unit is cooled by an air conditioner

When this unit has condensation inside, it may not function

normally, Should this occur, leave the unit for a few hours,

then try to operate again.

Wall or ceiling mounting —The unit should not be mounted

on a wall or ceiling, unless specified in the Operating

Instructions.

Electric Power

1 Power eources — Connect this unit only to power sources

specified in the Operating Instructions, and as marked on the

unit.

2 Polarization — As a safety feature, some units are equipped

with polarized AC power plugs which can only be inserted

one way into a power outlet. If it is difficult or impossible to

insert the AC power plug into an outlet, turn the plug over and

try again. If it still does not easily insert into the outlet, please

call a qualified service technician to service or replace the

outlet. To avoid defeating the safety feature of the polarized

plug, do not force it into a power outlet.

3

4

5

AC power cord

- When disconnecting the AC power cord, pull it out by the

AC power plug. Do not pull the cord itself.

- Never handle the AC power plug with wet hands, as this

could result in fire or shock,

- Power cords should be routed to avoid being severely bent,

pinched, or walked upon. Pay particular attention to the coral

from the unit to the power socket,

- Avoid overloading AC power plugs and extension cords

beyond their capacity, as this could result in fire or shock.

Extension cord — To help prevent electric shock, do not

use a polarized AC power plug with an extension cord,

receptacle, or other outlet unless the polarized plug can be

completely inserted to prevent exposure of the blades of the

plug,

When not in use — Unplug the AC power cord from the AC

power plug it the unit will not be used for several months or

more. When the cord is plugged in, a small amount of current

continues to flow to the unit, even when the power is turnecl

off

Outdoor Antenna

1

2

Power lines — When connecting an outdoor antenna, make!

sure it is located away from power lines.

Outdoor antenna grounding — Be sure the antenna systeml

is properly grounded to provide protection against unexpected

voltage surges or static electricity build-up. Article 810 of the

National Electrical Code, ANS1/NFPA 70, provides informatiorl

on proper grounding of the mast, supporting structure, ancl

the lead-in wire to the antenna discharge unit, as well as the

size of the grounding unit, connection to grcmnding terminals,

and requirements for grounding terminals themselves.

Antenna Grounding According to the National Electrical Code

h

I ~- ANTENNALEAD‘“““’

. ANTENNA DISCHARGE UNIT

(NEC SECTION 810-20)

ELECTRIC

GROUNDING CONDUCTORS

(NEC SECTION 810.21)

GROUND CLAMPS

~ POWER SERVICE GROUNDING

“EC-NATIONAL ELEC1-RICAL CODE

ELECTRODE SYSTEM

(NEC ART 250 PART H)

Maintenance

Clean the unit only as recommended in the Operating

Instructions.

Damaqe Reauirina Service

Have the units serviced by a qualified service technician if:

- The AC power cord or plug has been damaged

- Foreign objects or liquid have gotten inside the unit

- The unit has been exposed to rain or water

- The unit does not seem to operate normally

- The unit exhibits a marked change in performance

- The unit has been dropped, or the cabinet has been damageci

DO NOT ATTEMPT TO SERVICE THE UNIT YOURSELF.

❑

ENGLISH ;!

Évaluation

En savoir plus sur ce mode d’emploi

Nous comprenons qu’il est agréable d’avoir un mode d’emploi papier pour vos Aiwa NSX-V8000 Stéréo. Vous pouvez toujours télécharger le mode d’emploi depuis notre site Web et l’imprimer vous-même. Si vous souhaitez disposer d’un mode d’emploi original, nous vous recommandons de contacter Aiwa. Ils pourront peut-être fournir un mode d’emploi original. Recherchez-vous le mode d’emploi de votre Aiwa NSX-V8000 Stéréo dans une autre langue ? Choisissez votre langue préférée sur notre page d’accueil et recherchez le numéro de modèle pour voir si nous l’avons disponible.

Caractéristiques

Tous les modes d’emploi pour Aiwa Stéréos
Plus de modes d’emploi de Stéréos

Produits connexes

Mode d’emploi

Aiwa LCX-357 Stéréo

Mode d’emploi

Aiwa NSX-MA545 Stéréo

Mode d’emploi

Aiwa NSX-AJ20 Stéréo

Mode d’emploi

Aiwa XR-MR5 Stéréo

Mode d’emploi

Aiwa Z-L70 Stéréo

Mode d’emploi

Aiwa NSX-MT241 Stéréo

Mode d’emploi

Aiwa NSX-A10 Stéréo

Mode d’emploi

Aiwa LCX-151 Stéréo

Catégories associées