- In versions not equipped with TSS device, do not
operate the cleaner for more than 1-2 minutes with
the gun closed as this could damage the seals.
- Protect the cleaner from freezing during the winter.
- Do not obstruct the ventilation grilles during
operation.
- The cross-section of any extension cables used must
be proportional to their length, i.e. the longer the
extension cable, the greater the crosssection; cables
with a protection level of "IPX5" must be used.
- Position the cleaner AS NEAR POSSIBLE to the
water supply.
- The packaging is easily recyclable, and must be
disposed of in compliance with the regulations in
force in the country of installation.
- Use the cleaner only with accessories and
replacement parts authorised by the manufacturer.
The use of original accessories and replacement
parts will ensure safe, trouble-free operation.
- The cleaner must be used standing on a secure, stable
surface, positioned as shown. Fig. 3A.
SAFETY "MUST NOTS"
- EXPLOSION OR POISONING.
DO NOT use the cleaner with inflammable or toxic
liquids, or any products which are not compatible
with the correct operation of the cleaner.
- INJURY HAZARD.
DO NOT direct the water jet towards people or
animals.
- ELECTRIC SHOCK HAZARD.
DO NOT direct the water jet towards the unit itself,
electrical parts or towards other electrical
equipment.
- SHORT CIRCUIT HAZARD.
DO NOT use the cleaner outdoors in case of rain.
- INJURY HAZARD.
DO NOT allow children or incompetent persons to
use the cleaner.
- ELECTRIC SHOCK HAZARD.
DO NOT touch the plug and/or socket with wet
hands.
- ELECTRIC SHOCK AND SHORT CIRCUIT
HAZARD.
DO NOT use the cleaner if the electrical cable is
damaged.
- EXPLOSION HAZARD.
DO NOT use the cleaner if the high pressure hose is
damaged.
- ACCIDENT HAZARD.
DO NOT jam the trigger in the operating position.
- ACCIDENT HAZARD.
Check that the data plates are affixed to the cleaner,
if not, inform your dealer. Cleaners without plates
must NOT be used as they are unidentifiable and
potentially dangerous.
- EXPLOSION HAZARD.
DO NOT tamper with or with or alter the
calibration of the safety valve.
- HAZARDOUS ALTERATION OF OPERATING
PERFORMANCE.
DO NOT alter the original diameter of the spray
head nozzle.
- ACCIDENT HAZARD.
DO NOT leave the cleaner unattended.
- SHORT CIRCUIT HAZARD. DO NOT move the
cleaner by pulling on the electrical cable.
SAFETY "MUSTS"
- SHORT CIRCUIT HAZARD.
All electrical conductors MUST BE PROTECTED
against the water jet.
- ELECTRIC SHOCK HAZARD.
The cleaner MUST ONLY BE CONNECTED to a
correctly earthed power supply.
• Use of a safety residual current circuitbreaker
(R.C.C.B.) will provide additional protection for
the operator (30 mA).
- INJURY HAZARD.
The high pressure may cause materials to bounce off
surfaces at speed; therefore protective clothing and
safety goggles MUST BE WORN.
- ACCIDENTAL START-UP HAZARD.
Before doing work on the cleaner, REMOVE the
plug.
- INJURY HAZARD.
Before pressing the trigger, GRIP the gun firmly to
counteract the recoil.
- CONTAMINATION HAZARD.
COMPLY WITH the requirements of the local water
supply company. According to DIN 1988, power-jet
cleaners may only be connected to the mains
drinking water supply if a backflow preventer valve
with drain facility is installed in the supply hose.
- ACCIDENT HAZARD.
Maintenance and/or repair of electrical components
MUST be carried out by qualified staff.
- INJURY HAZARD.
DISCHARGE residual pressure before
disconnecting the cleaner hose.
- ACCIDENT HAZARD.
Before using the cleaner, CHECK every time that the
screws are fully tightened and that there are no
broken or worn parts.
- EXPLOSION AND ELECTRIC SHOCK HAZARD.
Only USE detergents which will not corrode the
coating materials of the high pressure hose/electrical
cable.
- INJURY HAZARD.
ENSURE that all people or animals keep a minimum
distance of 16 yd. (15m) away.
SAFETY VALVE
The safety valve also functions as a pressure limiting
valve. When the gun trigger is released, the safety valve
opens and the water recirculates through the pump
inlet.
Ferm 5
. ,
.
1 2 ,
.
,
30 cm (10 )
, .
.
-
.
.
-
.
- .
- .
-
/
.
.
- ,
50
. 6A
-
,
.
,
(
). 6B
- ,
.
-
.
( 6C),
( 6D) .
,
.
.
, ,
.
, , , .
.
o .
,
,
Ferm.
.
, .
.
.
.
92 Ferm
Joignez-vous à la conversation sur ce produit
Ici, vous pouvez partager ce que vous pensez du FERM GRM1004 Nettoyeur haute pression. Si vous avez une question, lisez d’abord attentivement le mode d’emploi. La demande d’un mode d’emploi peut être effectuée en utilisant notre formulaire de contact.