Home > Jouets > Hot Wheels Jouets > Hot Wheels Powerburst Figure 8 Track Set

Mode d’emploi Hot Wheels Powerburst Figure 8 Track Set

Besoin d'un mode d’emploi pour votre Hot Wheels Powerburst Figure 8 Track Set ? Ci-dessous, vous pouvez consulter et télécharger gratuitement le mode d’emploi PDF en français. Ce produit a actuellement 0 questions fréquemment posées, 0 commentaires et 0 votes. Si ce n'est pas le mode d’emploi que vous souhaitez, veuillez nous contacter.

Votre produit est défectueux et le mode d’emploi n’offre aucune solution ? Rendez-vous à un Repair Café pour obtenir des services de réparation gratuits.

Mode d’emploi

To Play

CHARGE THE CAR

Press and hold the car on the charger. Hold for approximately 10

seconds to get a good charge. Run the car until it needs recharging.

POWERBURST FIGURE 8POWERBURST FIGURE 8POWERBURST FIGURE 8

CONTENTS

TRACK SET TR

CK SET

TRACK SET

INSTRUCTIONS

INSTRUCTIONSINSTRUCTIONS

M4552-0920

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Note: Changes or modiﬁcations not expressively approved by the manufacturer

responsible for compliance could void the user’s authority to operate the equipment.

Mattel, Inc., 333 Continental Blvd., El Segundo, CA 90245 U.S.A. Consumer Relations 1 (800) 524-8697

service.mattel.com. Mattel Canada Inc., Mississauga, Ontario L5R 3W2. You may call us free at/ Composez sans

frais le 1-800-524-8697. Mattel U.K. Ltd., Vanwall Business Park, Maidenhead SL6 4UB.

Mattel Australia Pty., Ltd., Richmond, Victoria. 3121.Consumer Advisory Service - 1300 135 312.

Mattel East Asia Ltd., Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.

Diimport & Diedarkan Oleh: Mattel SEA Ptd Ltd.(993532-P) Lot 13.5, 13th Floor, Menara Lien Hoe, Persiaran

Tropicana Golf Country Resort, 47410 PJ. Tel:03-78803817, Fax:03-78803867.

SPEED RACER MOVIE: © Warner Bros. Entertainment Inc. SPEED RACER: ™ Speed Racer Enterprises, Inc.

(s08)

INSTRUCTION SHEET

SPECIFICATIONS

Toy:

Toy No.:

Part No.:

Trim Size:

Folded Size:

Type of Fold:

# colors:

Colors:

Paper Stock:

Paper Weight:

EDM No.:

M4552

0920

33"W x8.5" H

5.5" W x8.5" H

accordian

2C + 2C

PMS 485C + Black

White Offset

100 lb.

• This product is not recommended for use on loose dirt or

wet surfaces.

• Do not immerse in water.

• Only use charger supplied with this toy.

• Do not use any other charging source.

• Do not attempt to hold wheels while charging. Wheels must

spin during charging period.

• During charging, the vehicle may cause radio or television

interference. If so, move the vehicle away from the item

being interfered with.

• Do not attempt to recharge a charged vehicle. Additional

charging will not increase running time.

• Do not recharge the vehicle if it feels hot. Allow it to cool

before recharging.

• Do not attempt to use or charge the vehicle if it shows

signs of leakage or corrosion. If the vehicle and /or charger

get wet, discontinue use until they are completely dry.

Thoroughly wipe off all moisture and allow to air dry

completely before use.

CAUTION: To prevent entanglement,

keep hair away from wheels.

CAUTION: Vehicle contains a rechargeable cell.

if ﬂuid leaks, avoid contact with eyes and

discard vehicle.

Squeeze in ends of track at each connection.

Spread out opposite ends as shown.

TRACK TIPS FOR BEST RACE ACTION

SPREAD ENDS OF TRACK

LEADING OUT OF CURVE

SQUEEZE ENDS OF TRACK

LEADING IN TO CURVE

x 2

Keep these instructions for future reference as they contain important information.

Requires 3 “AA” (LR6) alkaline batteries. Batteries included are for demonstration purposes.

Refer to numbers on parts and contents page to help with assembly.

M4552-0920 Size: 8.5” x 33” Color: 2C + 2C

ASSEMBLY

FINAL ASSEMBLY

SKID LEVER

Press the skid levers on

either side of the track

and try to knock off your

opponent.

Battery Installation / Replacement

Protect the environment by not disposing of this

product with household waste (2002/96/EC). Check your

local authority for recycling advice and facilities.

BATTERY SAFETY INFORMATION

In exceptional circumstances batteries may leak ﬂuids that

can cause a chemical burn injury or ruin your product. To

avoid battery leakage:

• Non-rechargeable batteries are not to be recharged.

• Rechargeable batteries are to be removed from the

product before being charged (if designed to be

removable).

• Rechargeable batteries are only to be charged under

adult supervision (if designed to be removable).

• Do not mix alkaline, standard (carbon-zinc), or

rechargeable (nickel-cadmium) batteries.

• Do not mix old and new batteries.

• Only batteries of the same or equivalent type as

recommended are to be used.

• Batteries are to be inserted with the correct polarity.

• Exhausted batteries are to be removed from the product.

• The supply terminals are not to be short-circuited.

• Dispose of battery(ies) safely.

• Do not dispose of this product in a ﬁre. The batteries

inside may explode or leak.

Remove battery cover with a Phillips head

screwdriver (not included). Remove batteries

included for demonstration purposes and

dispose of them safely. Insert 3 new "AA" (LR6)

alkaline batteries in the orientation shown.

Replace battery cover and tighten screw. For best

performance use only alkaline batteries. Replace

batteries if booster no longer propels cars

through the set.

BOTTOM VIEW

Évaluation

Dites-nous ce que vous pensez du Hot Wheels Powerburst Figure 8 Track Set en laissant une note de produit. Vous voulez partager vos expériences avec ce produit ou poser une question ? Veuillez laisser un commentaire au bas de la page.

Etes-vous satisfait du Hot Wheels Powerburst Figure 8 Track Set ?
Oui Non

Soyez le premier à évaluer ce produit

0 évaluations

Joignez-vous à la conversation sur ce produit

Ici, vous pouvez partager ce que vous pensez du Hot Wheels Powerburst Figure 8 Track Set. Si vous avez une question, lisez d’abord attentivement le mode d’emploi. La demande d’un mode d’emploi peut être effectuée en utilisant notre formulaire de contact.

En savoir plus sur ce mode d’emploi

Nous comprenons qu’il est agréable d’avoir un mode d’emploi papier pour vos Hot Wheels Powerburst Figure 8 Track Set. Vous pouvez toujours télécharger le mode d’emploi depuis notre site Web et l’imprimer vous-même. Si vous souhaitez disposer d’un mode d’emploi original, nous vous recommandons de contacter Hot Wheels. Ils pourront peut-être fournir un mode d’emploi original. Recherchez-vous le mode d’emploi de votre Hot Wheels Powerburst Figure 8 Track Set dans une autre langue ? Choisissez votre langue préférée sur notre page d’accueil et recherchez le numéro de modèle pour voir si nous l’avons disponible.