Mode d’emploi Mottez A025PMON Porte-vélo

Besoin d'un mode d’emploi pour votre Mottez A025PMON Porte-vélo ? Ci-dessous, vous pouvez consulter et télécharger gratuitement le mode d’emploi PDF en français. Ce produit a actuellement 1 question fréquemment posée, 2 commentaires et a 4 votes avec une note moyenne du produit de 100/100. Si ce n'est pas le mode d’emploi que vous souhaitez, veuillez nous contacter.

Votre produit est défectueux et le mode d’emploi n’offre aucune solution ? Rendez-vous à un Repair Café pour obtenir des services de réparation gratuits.

Mode d’emploi

Loading…

ENGLISH
7a – Fitting the lower straps to the side beams:
- Pass the two hooks B through the loops formed by the lower straps A.
- Attach the lower straps under the vehicle to the metal side beams or metal hooks.
- Ensure that the straps are not too close to the silencer, as there is a risk of damage.
Fixing to the bumper is not permitted
7b – Fitting the lower straps on to the tailgate:
- Attach to two lower straps to the lower metal rim of the tailgate.
NEVER SUPPORT ON A PLASTIC COMPONENT.
8 – Tightening the straps:
- Tighten the straps to obtain perfect positioning on the car.
- Check that everything is properly tightened by pushing the cycle carrier hard in all directions; it
should not move on the vehicle. If this is not the case, tighten all the straps again.
9 – Fitting the complete grip straps:
- Attach the complete grip straps (red), C and D, to the cycle carrier’s framework.
10 – Strapping on the bicycles:
- Position the first bicycle with the chain facing towards the vehicle.
- Fit the bicycles alternately facing in the opposite direction, so that the handlebars do not foul on each
other.
- The bicycles must be distributed correctly on the cycle carrier, snugly and as close to the vehicle as
possible. The centre of gravity of the assembly must be as low as possible, without the bicycles being
able to touch the ground when passing over an obstacle (speed bump, etc.).
- Loads sticking out beyond the cycle carrier must comply with current regulations and must be
appropriately fixed. It is the user’s responsibility to comply with the standards applying in each country
where the carrier is used.
E.g. In France the load must not exceed a total width of 2.5 m.
- Ensure that cycle tyres are not too close to the vehicle’s tail pipe; hot exhaust gases could damage
them.
11 – Strapping on the bicycles:
- It is essential to fix the bicycle frames using straps E, securing them firmly to the cycle carrier’s
frame.
ATTENTION: THESE STRAPS PROVIDE YOUR SAFETY.
12 – Complete grip of the bicycles:
- Pass the complete grip straps, C and D (red), through the wheels: they prevent the bicycles falling
off.
- They ensure that the bicycles are held on the frame.
ATTENTION: THESE STRAPS PROVIDE YOUR SAFETY.
13 – Checking the tightness of the straps:
- The lower cycle carrier straps must be re-tightened.
- Check the other straps to ensure that there is no movement.
- Check that everything is properly tight by attempting to move the bicycles; they must not move on the
cycle carrier. If this is not the case, tighten all the straps again.
- Do not allow the straps to flap in the wind; use the elastic straps E provided.
14 - Use:
- Comply with current regulations and the Highway Code.
-We draw your attention to the fact that incorrect installation or use can result in danger for you and
others, for which you may be held liable.
Télécharger mode d’emploi en Français (PDF, 4.86 MB)
(Tenez compte de l’environnement et imprimez ce manuel uniquement si c’est vraiment nécessaire)

Loading…

Évaluation

Dites-nous ce que vous pensez du Mottez A025PMON Porte-vélo en laissant une note de produit. Vous voulez partager vos expériences avec ce produit ou poser une question ? Veuillez laisser un commentaire au bas de la page.
Etes-vous satisfait du Mottez A025PMON Porte-vélo ?
Oui Non
100%
0%
4 évaluations

Joignez-vous à la conversation sur ce produit

Ici, vous pouvez partager ce que vous pensez du Mottez A025PMON Porte-vélo. Si vous avez une question, lisez d’abord attentivement le mode d’emploi. La demande d’un mode d’emploi peut être effectuée en utilisant notre formulaire de contact.

Elisa Pardini 20-11-2020
Peut-il être monté sur une Opel mokka ?

répondre | Cela a été utile (0) (Traduit par google)
Daniele Silvestri 03-12-2020
Bonjour, je voulais savoir s'il existe un modèle compatible avec Renault scénique 4, imm. 2017. Merci

répondre | Cela a été utile (0) (Traduit par google)

En savoir plus sur ce mode d’emploi

Nous comprenons qu’il est agréable d’avoir un mode d’emploi papier pour vos Mottez A025PMON Porte-vélo. Vous pouvez toujours télécharger le mode d’emploi depuis notre site Web et l’imprimer vous-même. Si vous souhaitez disposer d’un mode d’emploi original, nous vous recommandons de contacter Mottez. Ils pourront peut-être fournir un mode d’emploi original. Recherchez-vous le mode d’emploi de votre Mottez A025PMON Porte-vélo dans une autre langue ? Choisissez votre langue préférée sur notre page d’accueil et recherchez le numéro de modèle pour voir si nous l’avons disponible.

Caractéristiques

Marque Mottez
Modèle A025PMON
Catégorie Porte-vélos
Type de fichier PDF
Taille du fichier 4.86 MB

Tous les modes d’emploi pour Mottez Porte-vélos
Plus de modes d’emploi de Porte-vélos

Foire aux questions sur Mottez A025PMON Porte-vélo

Notre équipe d’assistance recherche des informations utiles sur les produits et des réponses aux questions fréquemment posées. Si vous trouvez une inexactitude dans notre foire aux questions, veuillez nous le faire savoir en utilisant notre formulaire de contact.

À quelle vitesse puis-je rouler avec un porte-vélo, fixé à ma voiture ? Vérifié

En général, Il n'y a pas de limite exacte. Cependant, un porte-vélo, peut influencer la conduite du véhicule. C’est pourquoi il est conseillé de ne pas dépasser 130 kilomètres - heure.

Cela a été utile (945) En savoir plus
Mode d’emploi Mottez A025PMON Porte-vélo

Produits connexes

Catégories associées

×
Download