Mode d’emploi Philips QC5126 Tondeuse

Mode d’emploi

Introduction

Congratulations on your purchase and welcome to

Philips! To fully benet from the support that Philips offers,

register your product at www.philips.com/welcome.

General description (Fig. 1)

A Hair clipping comb

B Length setting selector

C Cutting element

D On/off slide

E Socket for appliance plug

F Appliance plug

G Adapter

H Cleaning brush

Important

Read this user manual carefully before you use the

appliance and save it for future reference.

Danger

- Make sure the adapter does not get wet.

Warning

- Check if the voltage indicated on the adapter and on

the appliance corresponds to the local mains voltage

before you connect the appliance.

- The adapter contains a transformer. Do not cut

off the adapter to replace it with another plug, as

this causes a hazardous situation.

- This appliance is not intended for use by persons

(including children) with reduced physical, sensory

or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a

person responsible for their safety.

- Children should be supervised to ensure that they

do not play with the appliance.

Caution

- Never immerse the appliance in water or any other

liquid, nor rinse it under the tap.

- Do not use the appliance in the bath or in the

shower.

- Use and store the appliance at a temperature

between 15°C and 35°C.

- Only use the appliance in combination with the

adapter supplied.

- If the adapter is damaged, always have it replaced

with one of the original type in order to avoid a

hazard.

- Do not use the appliance if the cutting element or

the hair clipping comb is damaged or broken, as this

may cause injury.

- This appliance is only intended for clipping human

scalp hair. Do not use it for any other purpose.

General

- The adapter transforms 220-240 volts to a safe low

voltage of less than 24 volts.

- This is appliance is not rechargeable and can only be

operated from the mains.

Compliance with standards

This Philips appliance complies with all standards

regarding electromagnetic elds (EMF). If handled

properly and according to the instructions in this user

manual, the appliance is safe to use based on scientic

evidence available today.

Using the appliance

1 Insert the appliance plug into the appliance (Fig. 2).

2 Put the adapter in the wall socket.

Clipping with hair clipping comb

Note: Make sure your hair is clean and dry. Do not use the

appliance on freshly washed hair.

1 Comb your hair with a styling comb in the

direction of hair growth. (Fig. 3)

2 Slide the hair clipping comb into the guiding

grooves of the appliance (‘click’) (Fig. 4).

Make sure that the arms of the comb have been properly

slid into the grooves on both sides.

3 Press the length setting selector (1) and then move

the hair clipping comb up or down (2) to set the

desired length setting (Fig. 5).

, The corresponding hair length is visible on the side

of the comb.

Length settings

With the hair clipping comb attached, the appliance can

cut hair to 10 different lengths:

Hair lengths in mm Hair lengths in inches

3 1/8

5 3/16

7 9/32

9 3/8

11 7/16

13 1/2

15 5/8

17 21/32

19 3/4

21 7/8

4 Slide the on/off slide upwards to switch on the

appliance (Fig. 6).

5 Place the hair clipping comb on the scalp and move

the appliance through the hair slowly.

Tips

- Start clipping at the highest length setting of the

hair clipping comb and reduce the length setting

gradually.

- Write down the length settings you have used to

create a certain hairstyle as a reminder for future

clipping sessions.

- To clip in the most effective way, move the appliance

against the direction of hair growth.

- Since hair grows in different directions, you need

to move the appliance in different directions as well

(upward, downward or across) (Fig. 7).

- Make overlapping passes over the head to ensure

that the appliance catches all the hairs that need to

be cut.

- Make sure that the at part of the hair clipping comb

is fully in contact with the scalp to obtain an even

clipping result.

- To achieve a good result with curly, sparse or long

hair, you can use a styling comb to guide the hair

towards the appliance.

- Regularly remove cut hair from the hair clipping

comb. If a lot of hair has accumulated in the comb,

remove it from the appliance and blow and/or shake

the hair out of it.

Clipping without hair clipping comb

You can use the appliance without hair clipping comb

to clip your hair very close to the skin (0.8mm) or to

contour the neckline and the area around the ears.

1 To remove the hair clipping comb, press the length

setting selector (1), move the comb upwards and

then pull it off the appliance (2). (Fig. 8)

2 Comb the hair ends over the ears before you start

to contour the hairline.

3 Slide the on/off slide upwards to switch on the

appliance (Fig. 6).

4 Tilt the appliance in such a way that only one

edge of the cutting element touches the hair

ends. (Fig. 9)

5 Only cut the hair ends. The hairline has to be close

to the ear.

6 To contour the neckline and the sideburns, turn the

appliance and make downward strokes (Fig. 10).

7 Move the appliance slowly and smoothly. Follow the

natural hairline.

Cleaning

Never use compressed air, scouring pads, abrasive

cleaning agents or aggressive liquids such as alcohol,

petrol or acetone to clean the appliance.

Only clean the appliance and the adapter with the

cleaning brush supplied.

Do not use any sharp objects to clean the appliance.

Clean the appliance after every use.

1 Make sure the appliance is switched off and

disconnected from the mains.

2 To remove the comb, press the length setting

selector (1), move the comb upwards and then pull

it off the appliance (2). (Fig. 8)

3 Push the middle part of the cutting unit upwards

with your thumb until it opens (Fig. 11).

4 Clean the cutting unit with the cleaning brush

supplied (Fig. 12).

5 Clean the inside of the appliance with the cleaning

brush supplied (Fig. 13).

Note: The appliance does not need any lubrication.

Replacement

The cutting unit, the adapter and the hair clipping comb

are replaceable.

Replacing the cutting unit

Replace the cutting unit if it is damaged or worn. Only

replace the cutting unit with an original Philips cutting unit.

1 Push the middle part of the cutting unit upwards

with your thumb until it opens and then pull it off

the appliance (Fig. 14).

2 Place the lug of the new cutting unit in the slot

and push the cutting unit onto the appliance

(‘click’) (Fig. 15).

Environment

- Do not throw away the appliance with the normal

household waste at the end of its life, but hand it in

at an ofcial collection point for recycling. By doing

this, you help to preserve the environment (Fig. 16).

Guarantee and service

If you need service or information or if you have a

problem, please visit the Philips website at www.

philips.com or contact the Philips Consumer Care

Centre in your country (you nd its phone number

in the worldwide guarantee leaet). If there is no

Consumer Care Centre in your country, go to your

local Philips dealer.

ENGLISH

2

4222.002.8084.2

Évaluation

En savoir plus sur ce mode d’emploi

Nous comprenons qu’il est agréable d’avoir un mode d’emploi papier pour vos Philips QC5126 Tondeuse. Vous pouvez toujours télécharger le mode d’emploi depuis notre site Web et l’imprimer vous-même. Si vous souhaitez disposer d’un mode d’emploi original, nous vous recommandons de contacter Philips. Ils pourront peut-être fournir un mode d’emploi original. Recherchez-vous le mode d’emploi de votre Philips QC5126 Tondeuse dans une autre langue ? Choisissez votre langue préférée sur notre page d’accueil et recherchez le numéro de modèle pour voir si nous l’avons disponible.

Caractéristiques

Tous les modes d’emploi pour Philips Tondeuses
Plus de modes d’emploi de Tondeuses

Foire aux questions sur Philips QC5126 Tondeuse

Notre équipe d’assistance recherche des informations utiles sur les produits et des réponses aux questions fréquemment posées. Si vous trouvez une inexactitude dans notre foire aux questions, veuillez nous le faire savoir en utilisant notre formulaire de contact.

Produits connexes

Mode d’emploi

Philips QG3362 Tondeuse

Mode d’emploi

Philips QC5053 Tondeuse

Mode d’emploi

Philips QC5132 Tondeuse

Mode d’emploi

Philips QG3333 Tondeuse

Mode d’emploi

Philips QC5010 Tondeuse

Mode d’emploi

Philips QG3080 Tondeuse

Mode d’emploi

Philips HC3518 Tondeuse

Mode d’emploi

Philips HC5650 Tondeuse

Catégories associées