Mode d’emploi Rosières RDR 91/1 AV Hotte aspirante

Mode d’emploi

replaced. To restart the hour counter (RESET), hold the button A pressed down for about 1” (while the pilot lamp

S is on). Button B: drives the motor in first speed (the corresponding pilot lamp comes on); when holding it down

for about 1”, the motor cuts out; when pressing the button a second time (while the pilot lamp is on) , the TIMER

is activated and thus the motor stops after 5’ (the pilot lamp flashes). Button C: drives the motor in second speed

(the corresponding pilot lamp comes on); when pressing the button a second time (while the pilot lamp is on) ,

the TIMER is activated and thus the motor stops after 5’ (the pilot lamp flashes). Button D: drives the motor in

third speed (the corresponding pilot lamp comes on); when pressing the button a second time (while the pilot lamp

is on) , the TIMER is activated and thus the motor stops after 5’ (the pilot lamp flashes). Button E: drives the

motor in fourth speed (the corresponding pilot lamp comes on); when pressing the button a second time (while

the pilot lamp is on) , the TIMER is activated and thus the motor stops after 5’ (the pilot lamp flashes).

Pay special attention to the grease filters; to remove the filter: push inward on the clamp at the handle and

pull the filter downward. Wash out the filter using a neutral soap. if the model purchased has the controls shown

in Figure 13: see the paragraph “Controls shown in Fig. 13” (“Filter Alarm”). If the model purchased has the controls

shown in Figure 11/12: the grease filter must be cleaned periodically: exactly how often depends on use (at least

once every other month). If the model purchased has the controls shown in Figure 14: the grease filters must

be cleaned approximately once every 30 hours of operation (when the light button lamp comes on) - Fig. 14S).

Once the cleaned filters are reinstalled, to reset the counter hold the light button pressed down for about 1”

(Fig.14A) while the corresponding pilot lamp (S) is on. For further information, see the Controls in Fig.14 in the

paragraph entitled “Operation”.

Charcoal filter/s: if using the hood in the filtering hood, the charcoal filter must be replaced periodically. To

remove the charcoal filters, proceed as follows, depending on the model purchased:

- if the hood features round charcoal filters (Fig. 15), remove the charcoal filter by turning clockwise.

- if the hood features a panel type charcoal filter (Fig. 10), remove the charcoal filter by first of all removing the

two filter retainers M.

If the model purchased has the controls shown in Figure 13, see the paragraph “Controls shown in Fig. 13” (“Filter

Alarm”). If the model purchased has the controls shown in Figure 11/12, the charcoal filters must be replaced

according to use: on the average once every 6 months. If the model purchased has the controls shown in Figure14,

the charcoal filters must be replaced each time the light button (Fig.14S) lamp flashes (i.e. every 120 hours of

operation).

Lighting:

- To gain access to the bulbs, remove the grease filters as described above and remove the bulbs. Replace only

with CANDLE HALOGEN LAMP - Ø 35mm, E14–220-240 Vac, 28W or INCANDESCENT LAMP-E14–220-240 Vac,

40W

- If the halogen lamps shown in Fig. 16 need changing, slacken the ring nut in an anticlockwise direction and

remove the bulb itself. Replace with the same type of lamp. CAUTION: Do not handle glass bulb with bare hands.

- To change the halogen lamps shown in Fig. 17 open the cover levering from the proper slots. Replace with

the same type of lamp. CAUTION: Do not handle glass bulb with bare hands.

The motor used in this hood features a safety device (thermal cutout) that responds to temperature changes

For accidental reasons or due to installation faults, this device could engage and automatically shut off the

motor, thereby preventing serious damage to the equipment. In such cases, after allowing the motor to cool

down, the hood can be switched on again; the cause of the fault will nonetheless have to be remedied,

ensuring installation has been correctly made and that all the instructions in the Information sheet have been

complied with.

Évaluation

En savoir plus sur ce mode d’emploi

Nous comprenons qu’il est agréable d’avoir un mode d’emploi papier pour vos Rosières RDR 91/1 AV Hotte aspirante. Vous pouvez toujours télécharger le mode d’emploi depuis notre site Web et l’imprimer vous-même. Si vous souhaitez disposer d’un mode d’emploi original, nous vous recommandons de contacter Rosieres. Ils pourront peut-être fournir un mode d’emploi original. Recherchez-vous le mode d’emploi de votre Rosières RDR 91/1 AV Hotte aspirante dans une autre langue ? Choisissez votre langue préférée sur notre page d’accueil et recherchez le numéro de modèle pour voir si nous l’avons disponible.

Caractéristiques

Tous les modes d’emploi pour Rosières Hottes aspirantes
Plus de modes d’emploi de Hottes aspirantes

Foire aux questions sur Rosières RDR 91/1 AV Hotte aspirante

Notre équipe d’assistance recherche des informations utiles sur les produits et des réponses aux questions fréquemment posées. Si vous trouvez une inexactitude dans notre foire aux questions, veuillez nous le faire savoir en utilisant notre formulaire de contact.

Produits connexes

Mode d’emploi

Rosières RHG 545 PN Hotte aspirante

Mode d’emploi

Rosières RHP 97000 LIN Hotte aspirante

Mode d’emploi

Rosières RHC 224/1 PN Hotte aspirante

Mode d’emploi

Rosières RDR 61 VV Hotte aspirante

Mode d’emploi

Rosières RHG 545 RB Hotte aspirante

Mode d’emploi

Rosières RDM 61 IN Hotte aspirante

Mode d’emploi

Rosières RSHD 90 IN Hotte aspirante

Mode d’emploi

Rosières RDR 91 RUV Hotte aspirante

Catégories associées