Mode d’emploi Worx WG601 Nettoyeur haute pression

Mode d’emploi

13A Electric Pressure Washer EN

2

PRODUCT SAFETY

WARNING: Read all safety warnings and

all instructions. Failure to follow the

warnings and instructions may result in

electric shock, fire and/or serious injury.

Save all warnings and instructions for future

reference.

WARNING: This product can expose you

to chemicals including lead and

Di(2-ethylhexyl)phthalate (DEHP) which

are known to the State of California to cause

cancer and birth defects or other reproductive

harm. For more information go to www.

P65Warnings.ca.gov.

IMPORTANT SAFETY INSTRUCTIONS

WARNING: When using this product basic

precautions should always be followed,

including the following:

1. Read all the instructions before using the

product.

2. To reduce the risk of injury, close supervision is

necessary when a product is used near children.

3. Know how to stop the product and bleed

pressures quickly. Be thoroughly familiar with

the controls.

4. Stay alert – watch what you are doing.

5. Do not operate the product when fatigued or

under the influence of alcohol or drugs.

6. Keep operating area clear of all persons

7. Do not overreach or stand on unstable support.

Keep good footing and balance at all times.

8. Follow the maintenance instructions specified in

the manual.

9. This Product Is Provided With A Ground Fault

Circuit Interrupter Built Into The Power Cord

Plug. If Replacement Of The Plug Or Cord Is

Needed, Use Only Identical Replacement Parts.

10. Do not spray electrical apparatus and wiring.

11. WARNING – To reduce the risk of

electrocution, keep all connections dry

and off the ground. Do not touch plug with wet

hands.

12. WARNING – Risk of injection or

injury– do not direct discharge stream at

persons.

SAVE THESE INSTRUCTIONS

CORD CONNECTED, DOUBLE INSULATED

PRODUCTS

1.GROUND FAULT CIRCUIT INTERRUPTER

PROTECTION

This pressure washer is provided with a ground-fault

circuit-interrupter (GFCI) built into the plug of the

power-supply cord. This device provides additional

protection from the risk of electric shock. Should

replacement of the plug or cord become necessary,

use only identical replacement parts that include GFCI

protection.

2. SERVICING OF A DOUBLE-INSULATED

APPLIANCE

In a double-insulated product, two systems of

insulation are provided instead of grounding. No

grounding means is provided on a double-insulated

product, nor should a means for grounding be added

to the product. Servicing a double-insulated product

requires extreme care and knowledge of the system,

and should be done only by

qualified service personnel. Replacement parts for a

double-insulated product must be identical to the parts

they replace.

3. EXTENSION CORDS

Use only extension cords that are intended for outdoor

use. These extension cords are identified by a marking

“Acceptable for use with outdoor appliances; store

indoors while not in use.” Use only extension cords

having an electrical rating not less than the rating of

the product. Do not use damaged extension cords.

Examine extension cord before using and replace if

damaged. Do not abuse extension cord and do not

yank on any cord to disconnect. Keep cord away from

heat and sharp edges. Always disconnect the extension

cord from the receptacle before disconnecting the

product from the extension cord.

SAFETY RULES FOR EXTENSION CORD

Make sure your extension cord is in good condition.

When using an extension cord, be sure to use one

heavy enough to carry the current your product will

draw. An undersized extension cord will cause a

drop in line voltage resulting in loss of power and

overheating. Table 1 shows the correct size to use

depending on cord length and nameplate ampere

rating. If in doubt, use the next heavier gage. The

smaller the gage number, the heavier the cord. To

reduce the risk of disconnection of appliance cord from

the extension cord during operating:

I) Make a knot as shown in Figure 1; or

II) Use one of the plug-receptacle retaining straps or

connectors described in this manual.

Table 1 Minimum gauge for extension cords

Volts Total length of cord in feet

120V 25 50 100 150

Ampere rating

more than not

more than

AWG

12-16

14 12

Not

recommended

FIGURE 1

METHOD OF SECURING EXTENSION CORD

CORD

SET

APPLIANCE CORD

Évaluation

En savoir plus sur ce mode d’emploi

Nous comprenons qu’il est agréable d’avoir un mode d’emploi papier pour vos Worx WG601 Nettoyeur haute pression. Vous pouvez toujours télécharger le mode d’emploi depuis notre site Web et l’imprimer vous-même. Si vous souhaitez disposer d’un mode d’emploi original, nous vous recommandons de contacter Worx. Ils pourront peut-être fournir un mode d’emploi original. Recherchez-vous le mode d’emploi de votre Worx WG601 Nettoyeur haute pression dans une autre langue ? Choisissez votre langue préférée sur notre page d’accueil et recherchez le numéro de modèle pour voir si nous l’avons disponible.

Caractéristiques

Tous les modes d’emploi pour Worx Nettoyeurs haute pression
Plus de modes d’emploi de Nettoyeurs haute pression

Foire aux questions sur Worx WG601 Nettoyeur haute pression

Notre équipe d’assistance recherche des informations utiles sur les produits et des réponses aux questions fréquemment posées. Si vous trouvez une inexactitude dans notre foire aux questions, veuillez nous le faire savoir en utilisant notre formulaire de contact.

Produits connexes

Mode d’emploi

Worx WG629E.91 Nettoyeur haute pression

Mode d’emploi

Worx WG620.9 Nettoyeur haute pression

Mode d’emploi

Worx WG620.5 Nettoyeur haute pression

Mode d’emploi

Worx WG607 Nettoyeur haute pression

Mode d’emploi

Worx WG620.7 Nettoyeur haute pression

Mode d’emploi

Worx WG629E.9 Nettoyeur haute pression

Mode d’emploi

Worx WG620.3 Nettoyeur haute pression

Mode d’emploi

Worx WG620.2 Nettoyeur haute pression

Catégories associées