Mode d’emploi Mellerware 20800A Tondeuse

Mode d’emploi

2.2. Personal safety:

2.2.1. CAUTION: Do not leave the appliance unattended

during use as there is a risk of an accident.

2.2.2. This appliance is only for domestic use, not for

industrial or professional use. It is not intended to be

used by guests in hospitality environments such as

bed and breakfast, hotels, motels, and other types of

residential environments, even in farm houses, offices

and other work environments.

2.2.3. This appliance is not intended for use by

persons (including children) with reduced physical,

sensory or mental capabilities, or lack of experience

and knowledge, unless they have been given supervi-

sion or instruction concerning use of the appliance by

a person responsible for their safety.

2.2.4. This appliance is not a toy. Children should be

supervised to ensure that they do not play with the

appliance.

2.3. Use and care:

2.3.1. Fully unroll the appliance’s power cable before

each use.

2.3.2. Do not use the appliance if the parts or acces-

sories are not properly fitted.

2.3.3. Unplug the appliance from the mains power

supply when not in use and before undertaking any

cleaning task.

2.3.4. This appliance should be stored out of reach

of children.

2.3.5. Do not store the appliance if it is still on/hot.

2.3.6. Never leave the appliance unattended when in

use and keep out of the reach of children.

2.3.7. If, for some reason, the appliance were to catch

fire, disconnect the appliance from the mains power

supply and DO NOT USE WATER TO PUT THE FIRE

OUT.

2.4. Service:

2.4.1. Make sure that the appliance is serviced only

by suitably qualified technician, and that only original

spare parts or accessories are used to replace existing

parts/accessories.

2.4.2. If the power cord is damaged, the manufacturer

or its service agent or a similarly qualified person must

replace it in order to avoid a hazard.

2.4.3. Any misuse or failure to follow the instructions

for use renders the guarantee and the manufacturer’s

liability null and void.

3. Instructions for use

3.1. Before use:

3.1.1. Remove the appliance’s protective film(if ap-

plicable).

3.1.2. Before using the product for the first time, clean

the parts that will come into contact with your head in

the manner described in the cleaning section.

3.2. Aligning your blades:

3.2.1. Your clippers were carefully examined to ensure

that the blades were oiled and aligned before leaving

the factory.

3.2.2. Blades must be realigned if they have been

removed for cleaning or replacement.

3.2.3. To realign the blades, each upper blade tip

should be in line with the corresponding lower blade

tip.

(The bottom blade’s teeth tips should be approximately

1.2mm below the top blade’s teeth tips.)

3.2.4. If blade alignment is incorrect, add a few drops

of oil to the blades, switch on the clipper for a few

seconds, switch off and unplug. Loosen the screws

slightly and adjust. Tighten the screws again after the

blade is aligned.

3.2.5. To change the blades, use a Phillips screw driver

to loosen the 2 screws.

3.2.6. Remove blade and replace it with a new blade.

3.2.7. Align the top blade then place the bottom blade

over the top blade and insert the screws and tighten

slightly.

3.2.8. Align the bottom blade as explained above and

tighten the screws further to secure the bottom blade

in place.

3.3. Oiling your clipper blades

3.3.1. To keep your clipper in peak condition, the

blades should be oiled before every use.

3.3.2. Do not use hair oil, grease, and oil mixed with

kerosene or any other solvent. The solvent will evapo-

rate and leave a thick layer of oil which may slow down

the blade’s motion.

1.2mm

Évaluation

En savoir plus sur ce mode d’emploi

Nous comprenons qu’il est agréable d’avoir un mode d’emploi papier pour vos Mellerware 20800A Tondeuse. Vous pouvez toujours télécharger le mode d’emploi depuis notre site Web et l’imprimer vous-même. Si vous souhaitez disposer d’un mode d’emploi original, nous vous recommandons de contacter Mellerware. Ils pourront peut-être fournir un mode d’emploi original. Recherchez-vous le mode d’emploi de votre Mellerware 20800A Tondeuse dans une autre langue ? Choisissez votre langue préférée sur notre page d’accueil et recherchez le numéro de modèle pour voir si nous l’avons disponible.

Caractéristiques

Tous les modes d’emploi pour Mellerware Tondeuses
Plus de modes d’emploi de Tondeuses

Foire aux questions sur Mellerware 20800A Tondeuse

Notre équipe d’assistance recherche des informations utiles sur les produits et des réponses aux questions fréquemment posées. Si vous trouvez une inexactitude dans notre foire aux questions, veuillez nous le faire savoir en utilisant notre formulaire de contact.

Produits connexes

Mode d’emploi

SilverCrest IAN 377184 Tondeuse

Mode d’emploi

Taurus HC-0150 Tondeuse

Mode d’emploi

Camry CR 2844 Tondeuse

Mode d’emploi

Ufesa MB6000 Skipper Tondeuse

Mode d’emploi

Cecotec PrecisionCare AllDrive Pro Tondeuse

Mode d’emploi

Livoo DOS229N Tondeuse

Mode d’emploi

Tristar TR-2572 Tondeuse

Mode d’emploi

G3 Ferrari G30038 Appeal Tondeuse

Catégories associées